(2x) FuelCon EVALUATOR-C TEST STATIONS and more , Type 4200110

Description

Computer included for the Evaluator-C , Type 4200110
EIS Truedata included , These were pulled from a
closed
Test facility , have not tested selling as is , will need service upgrade from FuelCon .
Lot of
13
High-End Multi parameter Fuel Cell Text Station Equipment, selling in BULK
All these Came from a Fuel Cell Test station Lab we would like to cell in BULK , we can also break them up, let us know your preference.
Manufactured 2005
1x=Fuelcom Evaluator C , with Software and Computer , comes with TrueData EIS 2
0
and H&H Electronic Load ,
1x=Fuelcom Evaluator C , as a backup , with TrueData EIS 2
0
and H&H Electronic Load
1x= unknown Manufacturer Cabinet loaded with connections ( part of the Lab set up)
2 sets of Federis, manufactured in 2
00
5
2x = Fideris FCTS GMET
2x = Fideris FCTS EL power switches
1x = Fideris BH , Bubble Humidifier
2x= Connecting Units for the Federis Equiment (Black Boxes
2x = Digital Wet Gas Meters,by Jain Technology CO., Ltd , South Korea
Model
JWG 1
000
, 0.5 L Rev.   Flow Rate 25L/h to 3
00
L/h.         Max
p
ressure    1
00
K
pa
Model  JWG 1
000,
1
0
L Rev.   Flow Rate 3
00
L/h to 6000
L/h
Max
p
ressure.
1
00
K
pa
Info about TrueData-EIS Impedance Spectroscopy in the Fuelcom Evaluator C
TrueData-EIS
electrochemical impedance spectrometer is a high-capacity diagnostic tool to determine the impedance of fuel cells, membranes, MEAs, single cells, stacks, batteries and super capacitors. It uses a non-invasive method and allows the characterization of components during operation under different load conditions. The test item is stimulated with a small sinusoidal signal. The resulting signal response is measured with magnitude of impedance and phase over a larger frequency range.
The
TrueData-EIS impedance analyzer is based on the single-sine-method and enables, together with the used 32 bit processor technology, high precision and an easy integration in automated test systems for fuel cells and batteries. Typically, the TrueData-EIS is applied together with the electronic load TrueData-LOAD. In addition, the TrueData-EIS is compatible with various other electronic loads, potentiostats and galvanostats.
The
FuelCon TrueData-EIS allows impedance spectrums in a frequency range, which is particularyly interesting for the fuel cell development and manufactoring: from 200 µHz up to 100 kHz with a maximum DC current of 1,000 A. The complex circuitry design and sophisticated calibration performance ensure high reproducibility of measured data within the typically very low impedance values of fuel cells. A display with four keys allows a comfortable operation of the device.
Its
optimum performance is achieved when using the TrueData-EIS combined with the FuelCon Evaluator test station and the software TestWork. While measuring, the test results are displayed as a frequency response diagram or Nyquist diagram.  At the same time, the parameters of fuel cell operation are specified on-line. This allows the fully automated recording of the impedance spectrum under different, reproducibly adjusted operating points for single cells, short stacks and complete cell stacks.  Therefore it is ideal for material screening.